www.millerpaint.com
1-800-852-3254
Evolution®
Matte 1580 series

Bases Available: 1580 - White,   1582 - Medium,   1586 - Accent,   1588 - Neutral
Product Description     Specifications
Evolution Ceramic Matte Finish is our finest interior coating for use on walls where a durable flat finish is desired.  The matte finish offers the minimal light reflection of a flat with increased washability.
   
Color: Full range
Finish: Matte
Density: 12.1# per gallon
Clean-Up: Mild soap and water
VOC: 80 gm/liter
Solids: Weight
Volume
60.5%
44.5%
Flash Point: N/A
Coverage: 250-500 sq. ft. per gallon.  Two coats recommended. Coverage depends on porosity and profile of surface.  
Theoretical
Coverage:
370 sq. ft. @ 2 dry mils
Dry Time: Thirty minutes to touch and two hours to recoat @70°F and 50%. 
Application: Brush, roll or spray.
Features

Evolution Ceramic Matte Finish has been formulated with our finest 100% pure acrylic resin, Ceramic Technology and Microban antimicrobial protection.  This combination offers superior stain resistance, durability and washability. Covered by our Lifetime Warranty (see label for details).

Composition

100% Acrylic resin
Titanium Dioxide and extender pigments
Contains no lead or mercury












Surface Preparation
Surfaces must be sound, dry and clean. Remove previous coatings that have poor adhesion. Wash areas where mold and mildew are present. Remove all dirt, oil, grease, wax and/or other contaminant. Repair cracks and fill voids. De-gloss shiny surfaces by lightly sanding. Clean and prime all metal surfaces with an appropriate primer. Prime areas as needed. Test for adhesion and compatibility with existing finishes.

Disposal
Never pour leftover coating down any sink or drain—use up material on the job or seal can and store safely for future use. Do not incinerate closed containers. For specific disposal or recycle guidelines, contact your local waste management agency or district. Always attempt to recycle whenever possible.

Limited Lifetime Warranty
If this Evolution™ interior coating by Miller Paint Co., Inc., when applied in accordance with label instructions, fails to perform due to peeling, blistering or unusual wear for as long as you own the single-family home to which this paint was applied, then we will either replace the paint free of charge or refund the purchase price, upon presentation of proof of purchase. This warranty, which excludes failure due to deterioration of the underlying surface, structural defects or failure of previous paint, extends only to the owner of the single-family home to which the paint was applied during such owner’s occupancy, may not be transferred or assigned, and is your sole remedy.  THIS WARRANTY DOES NOT INCLUDE LABOR OR THE COST OF LABOR FOR THE APPLICATION OF ANY PRODUCT, AND EXCLUDES ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion of incidental or consequential damages, so the limitation may not apply to you.   This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Possible Existing Lead Warning
WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

Product Analysis figures should be taken as accurate for products being produced at the time of publication. Formulation improvements may be made from time to time that may affect these figures to some degree. Also, manufacturing tolerances of ±2% are considered acceptable. Whenever a change is made that the Manufacturer considers substantial, the Product Analysis will be revised.