An interior/exterior top quality acrylic emulsion based premium grade paint, in many ways equivalent
to solvent thinned enamels. Recommended for dimensionally stable, sealed surfaces such as metal and finish grade wood.
Not recommended for surfaces subject to moisture penetration and movement.
|
|
|
| Color: |
Full range |
|
| Finish: |
Gloss |
|
| Density: |
10.12# per gallon |
|
| Clean-Up: |
Mild soap and water |
|
| VOC: |
240 gm/liter minus water |
|
| Solids: |
Weight
Volume |
47.9%
36.3% |
|
| Flash Point: |
N/A |
|
| Coverage: |
300-400 sq. ft. per gallon
2 dry mil ideal film thickness |
|
Theoretical
Coverage: |
300 sq. ft. @ 2 dry mils |
|
| Dry Time: |
Allow 24 hours @ 70°F before recoating. Cooler temperatures or high humidity will
require longer dry time. |
|
| Application: |
Brush, roll or spray. Do not apply when surface or air temperatures are
below 50°F or above 90°F or in direct sunlight. |
|
Acrinamel has better color retention and weather resistance than most solvent thinned coatings.
Acrinamel also offers a harder finish than previously achieved by most acrylic latex paints. Acrinamel does not yellow as
do most alkyd finishes. Acrinamel provides easy clean up with warm soapy water. Do not apply less than 300 sq ft per
gallon or exceed 2 dry mils of finish in one coat.
|
Acrylic
Titanium dioxide & extender pigments
Contains no lead or mercury
VOC compliant
|
Surfaces must be sound, dry and clean. Remove previous coatings that have poor adhesion.
Wash areas where mold and mildew are present. Remove all dirt, oil, grease, wax and/or other contaminant. Repair
cracks and fill voids. De-gloss shiny surfaces by lightly sanding. Clean and prime all metal surfaces with an
appropriate primer. Prime areas as needed. Test for adhesion and compatibility with existing finishes.
|
Never pour leftover coating down any sink or drain—use up material on the job or seal can and
store safely for future use. Do not incinerate closed containers. For specific disposal or recycle guidelines, contact
your local waste management agency or district. Always attempt to recycle whenever possible.
|
Limited Warranty: Miller Paint Company, Inc. warrants to the purchaser that this product
will provide satisfactory performance when applied according to label directions. If this product does not perform
to specifications, return unused portion along with sales receipt to place of purchase. As the sole remedy to purchaser,
dealer will, at its option: provide additional product to correct affected areas, replace with product of equal value or
refund the purchase price paid for this paint product. Failures caused by poor surface preparation, improper application
or a breakdown of the underlying surface or previous paint film are not covered by this warranty. THIS WARRANTY
SPECIFICALLY EXCLUDES LABOR OR COST OF LABOR OR INCIDENTAL OR CONSEQUENTIAL DAMAGES ASSOCIATED WITH THE USE OF THIS PRODUCT.
|
WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD
ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum
and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
|
